5. Move the pickup roller shaft to the left to free the right end of the shaft from the holder, and then
remove the pickup roller shaft assembly to expose the separation pad.
Figure 1-6 Remove the MP tray separation pad (3 of 5)
Reinstallation tip The spring at the right end of the shaft is not captive and might fall off
during this process. Make sure that the spring is positioned correctly when reinstalling, as shown
in the following figure.
Figure 1-7 Remove the MP tray separation pad (4 of 5)
8 Chapter 1 Removal and replacement ENWW
For more information and parts on the HP LaserJet Pro 400, M425 call 800-551-1943 or order on line at www.printersupplies.com
To Next Page
Loading...