5. At the rear of the product, disconnect six connectors (callout 1), and then pull the wire guide
(callout 2) away from the product.
Figure 1-40 Remove the fuser (3 of 5)
11
NOTE: You do not need to unroute the disconnected wires from the wire guide.
6. Remove one screw (callout 1), remove the media feed guide (callout 2), and unroute the wire
(callout 3) at the corner of the engine controller assembly.
Figure 1-41 Remove the fuser (4 of 5)
2
3
1
30 Chapter 1 Removal and replacement ENWW
For more information and parts on the HP LaserJet Pro 400, M425 call 800-551-1943 or order on line at www.printersupplies.com
To Next Page
Loading...