1. Slide open the tray.
NOTE: Do not open the tray while it is in use.
2. Adjust the paper-length and paper-width guides by squeezing
the adjustment latch and sliding the guides to the size of the
paper being used.
3. Load paper into the tray face-up. Check the paper to verify
the guides lightly touch the stack, but do not bend it.
NOTE: To prevent jams, do not overfill the tray. Be sure the
top of the stack is below the tray full indicator.
NOTE: If the tray is not adjusted correctly, an error message
might display during printing or the paper might jam.
4. Slide the tray into the product.
ENWW Tray 2 25
To Next Page
Loading...