1. Slide open the tray.
NOTE: Do not open the tray while it is in
use.
2. Adjust the paper-length and paper-width
guides by squeezing the adjustment latch and
sliding the guides to the size of the paper
being used.
3. Load paper into the tray face-up. Check the
paper to verify the guides lightly touch the
stack, but do not bend it.
NOTE: To prevent jams, do not overfill the
tray. Be sure the top of the stack is below the
tray full indicator.
NOTE: If the tray is not adjusted correctly,
an error message might display during printing
or the paper might jam.
4. Slide the tray into the product.
ENWW
Tray 2
27
To Next Page
Loading...
