Solve problems checklist
Follow these steps when trying to solve a problem with the product.
●
Step 1: Make sure that the product is set up correctly
●
Step 2: Check the cabling or wireless connection (network models only)
●
Step 3: Check to see if any control-panel lights are lit
●
Step 4: Check the paper
●
Step 5: Check the software
●
Step 6: Test print functionality
●
Step 7: Check the supplies
●
Step 8: Try sending a print job from a computer
Step 1: Make sure that the product is set up correctly
Make sure that the product is set up correctly.
1. Press the power button to turn on the product or to deactivate the Auto-On\Auto-Off mode.
2. Check the power-cable connections.
3. Make sure that the line voltage is correct for the product power configuration. (See the label that is
on the back of the product for voltage requirements.) If you are using a power strip and its voltage
is not within specifications, plug the product directly into the wall. If it is already plugged into the
wall, try a different outlet.
4. Make sure that the print cartridge is installed correctly.
5. If none of these measures restores power, contact HP Customer Care.
Step 2: Check the cabling or wireless connection (network models
only)
1. Check the cable connection between the product and the computer. Make sure that the connection
is secure.
2. Make sure that the cable itself is not faulty by using a different cable, if possible.
Step 3: Check to see if any control-panel lights are lit
The control panel should indicate ready status. If an error message appears, resolve the error.
ENWW
Solve problems checklist
101
To Next Page
Loading...