Rear door and rear-lower cover
1. Remove the following components:
●
Right cover. See
Right cover on page 10.
●
Left cover. See
Left cover on page 13.
●
Rear-side cover. See
Rear-side cover on page 21.
2. Remove two screws (callout 1).
Figure 1-34 Remove the rear door and rear-lower cover (1 of 4)
1
3. Release one pin (callout 2), and then slide the rear door and rear-lower cover toward the side of
the product with the interface connectors.
Figure 1-35 Remove the rear door and rear-lower cover (2 of 4)
2
ENWW Removal and replacement procedures 23
To Next Page
Loading...