7. Release the wire harness (callout 10) from the retainer.
Figure 1-75 Remove the power supply (low-voltage; 6 of 10)
10
8. Release two tabs (callout 11), and then carefully remove the retainer (callout 12).
NOTE: It might be easier to remove this retainer if you first move the cable that connects the
formatter PCA out of the way, and hold the formatter PCA out and away from the chassis.
Figure 1-76 Remove the power supply (low-voltage; 7 of 10)
11
12
50 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...