5. Use the keypad on the touchscreen to enter the subnet mask, and touch the OK button. Touch the Yes
button to confirm.
6. Use the keypad on the touchscreen to enter the default gateway, and touch the OK button. Touch the
Yes button to confirm.
Link speed setting
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed of the print server must match the network hub. For most situations, leave the printer in
automatic mode. Incorrect changes to the link speed setting might prevent the printer from communicating
with other network devices. To make changes, use the printer control panel.
NOTE: The printer setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the printer to turn off and then on. Make changes only
when the printer is idle.
NOTE: The steps vary according to the type of control panel.
1 2
1 2-line control panel
2 Touchscreen control panel
1. 2-line control panels: On the printer control panel, press the Setup button.
Touchscreen control panels: From the Home screen on the printer control panel, swipe until the Setup
menu displays. Touch the Setup
icon to open the menu.
2. Open the following menus:
●
Network Setup
●
Link Speed
3. Select one of the following options:
●
Automatic: The print server automatically configures itself for the highest link speed and
communication mode allowed on the network.
●
10T Full: 10 megabytes per second (Mbps), full-duplex operation
●
10T Half: 10 Mbps, half-duplex operation
ENWW Configure IP network settings 113
To Next Page
Loading...