HP Latex 3000

HP Latex 3000 Printer Cleaning Kit contents
Part Quantity Use in maintenance
Flex cleaner and 12 flex sponges 1 Clean printhead contacts, printhead side (see
The Internal Print Server
recommends replacing or reseating a printhead on page 250)
Brush 1 Clean printhead contacts, carriage side (see
The Internal Print Server
recommends replacing or reseating a printhead on page 250)
Cotton swabs 100 Clean the substrate advance sensor (OMAS) (see
Clean the substrate-
advance sensor on page 178) and the line sensor (see Clean the bottom of
the carriage, the drying glasses, and the line sensor on page 126)
Carriage rail cleaning wicks 6 bags of 20 Cleaning (see
Clean the carriage rails and replace the oiler foams
on page 136)
Lubricant oil 3 bottles of 10
ml
Lubrication (see
Clean the carriage rails and replace the oiler foams
on page 136)
Oiler foams 6 bags of 2 Replacement (see
Clean the carriage rails and replace the oiler foams
on page 136)
Oiler wicks 6 sets Replacement (see
Clean the carriage rails and replace the oiler foams
on page 136)
Grease syringe 3 ml Grease small parts; but not for greasing carriage beam screws
Cleaning sponges 6 General cleaning
Plastic gloves 6 sets General maintenance processes
E-cabinet and e-box filters 6 sets of 2 Fan filters replacement (see
Replace the e-cabinet fan filters on page 156)
NOTE: The contents of the kit may vary.
NOTE: Some keys are provided with the printer. Please refer to the safety precautions section (see Safety
precautions on page 2) to identify the one you may require for maintenance operations.
Use the keys only for accessing the intended doors and keep them always under your control. Store them in a
safe and secure place.
Maintenance tools recommended but not provided
●
Spiral steel scourer, for
Clean the bottom of the carriage, the drying glasses, and the line sensor
on page 126; Replace the drying lamps on page 164; and Clean the ink deposits on page 132
114 Chapter 8 Hardware maintenance ENWW