13. Put the emptied collectors back into place.
14. Recheck that all the emptied collectors in the each accessed area are back in place.
Finish off after emptying the oil collector caps
1. Close the loading table and secure the latches.
2. Close the front door.
3. Put back the covers and screw them into place.
4. Close the printhead cleaning roll door.
5. Turn on the printer in the correct way for maintenance operations: see
Turn the printer on on page 120.
Replace the e-cabinet fan filters
Prepare to replace the e-cabinet fan filters
1. E-cabinet fan filters are provided with your printer in the HP Latex 3000 Printer Cleaning Kit: the
necessary sets of two filters are provided; only one set is needed for this operation.
156 Chapter 8 Hardware maintenance ENWW
To Next Page
Loading...
