3. Remove the spring that holds it from below.
4. Attach the spring to the new service station cap and place it in position.
Finish off after replacing a service station cap
1. Put back the cover and screw it into place.
2. Turn on the printer in the correct way for maintenance operations: see
Turn the printer on on page 120.
Replace an intermediate tank
Risk of burns Risk of trapped fingers Hazardous moving part
For more safety information, please see
Safety precautions on page 2
You will need to replace an intermediate tank if the bag breaks.
Prepare to replace an intermediate tank
1. Ensure that you have the Intermediate Tank Kit (CZ056-67073), which is included in the Standard
Uptime Kit (D4J02A).
2. Ensure that the printer is not printing.
3. Turn off the printer in the correct way for maintenance operations: see
Turn the printer off on page 119.
Replace an intermediate tank
1. Unscrew the pointed screws and remove the cover to access the intermediate tanks.
ENWW Replace an intermediate tank 205
To Next Page
Loading...
