4. Remove the piece of paper or cloth to prevent the dirt from spreading.
5. Use the pneumatic air gun to dislodge any remaining dirt.
6. Illuminate the printhead slot again to check that the electrical connections are now clean and
undamaged.
Clean the printhead contacts (on the printhead)
1. Take the printhead interconnect wiper provided in the HP Latex 3000 Printer Cleaning Kit. Prepare the
handle and one pre-moistened sponge in its pouch.
2. Take a sponge out of its pouch.
212 Chapter 8 Hardware maintenance ENWW
To Next Page
Loading...
