6. Clean the contacts.
CAUTION: Do not use the printhead interconnect wiper to clean the nozzles!
Finish off cleaning the printhead contacts
1. Wait until the contacts are dry.
2. Put back the printheads, each in the same slot from which it came.
3. Close the service position window.
4. Turn on the printer in the correct way for maintenance operations: see
Turn the printer on on page 120.
Replace a spindle valve
Risk of trapped fingers
For more safety information, please see
Safety precautions on page 2
214 Chapter 8 Hardware maintenance ENWW
To Next Page
Loading...
