◦
Increase the curing temperature and airflow.
◦
Decrease the ink density.
◦
Try repeating the Add New Substrate procedure in case you had wrong settings in the substrate
preset.
●
Diverter horizontal or vertical marks. These can be of two types:
◦
Horizontal marks: Deformations of the substrate in the shape of straight lines (about 6 cm long)
towards the printed side of the substrate. They are separated about 2 cm vertically and 1 cm
horizontally.
◦
Vertical marks: These physical marks have the appearance of a braid. They consist of small
wrinkles just below the curing module, forming a vertical line of small deformations.
Both kinds of deformations can be the result of an excessive curing temperature. See
There are physical
marks on the substrate on page 227.
248 Chapter 10 Troubleshoot print-quality issues ENWW
To Next Page
Loading...
