HP Latex 3000 - Page 278

maintenance off/on 119
maintenance tools 114
maintenance with Print Care 116
maintenance without Print Care
117
memory specifications 262
move the printer 14
N
nesting 67
O
oil collector caps
empty 148
oiler foams, replace 136
order
accessories 258
cleaning roll 96
ink cartridges 95
printheads 95
P
perforated plate
clean 162
physical specifications 262
pinchwheel submodule
replace 181
pinchwheels
clean 130
power specifications 262
prepare to print 29
primer
replace 183
Print Care restarts 257
print jobs 62
print layout 66
print modes 262
print queue 64
print zone
clean 125
print-quality problems
general 231
printer
move 14
printer cleaning kit 114
printer does not print 256
printer does not restart 256
printer does not start 256
printer not detected 257
printer on/off 13
first time 13
printer software 12
printer status 20
printer's main components 10
printer's main features 1
printhead
about 70
align 97
cannot insert 250
check and clean 81
insert 78
maintain 81
order 95
remove 75
reseat 250
specification 261
printhead alignment diagnostics
plot 101
printhead cleaner roll
about 71
printhead cleaning roll
errors 254
replace 88
printhead contacts
clean 209
printhead rejected 254
printing resolutions 261
printing speeds 261, 262
Proactive Support 259
R
Raster Image Processor 12
rear scan-axis beam
clean 176
recycle used supplies 96
RIP 12
adding jobs from 62
roll-to-collector configuration 52
roll-to-free-fall configuration 50
roll-to-free-fall roller
clean 216
roll-to-roll configuration 36
rotate a print job 64
rubber blade
replace 158
S
safe mode 82
safety labels 7
safety precautions 2
service information print 260
service station cap
replace 202
slow printing 256
software 12
specifications
acoustic 264
air supply 263
ecological 263
environmental 263
functional 261
hard disk 262
ink supplies 261
memory 262
physical 262
power 262
print modes 262
printing resolutions 261
printing speeds 261, 262
substrate size 261
spindle latch opens 222
spindle valve
replace 214
spittoon
about 71
replace 86
step and repeat 66
substrate
advance compensation 106
cannot load 220
configurations 28
detached from core 221
drops of ink 228
dual roll to roll 46
edit preset 57
ink marks 226
jammed 220
load into printer 35
load onto the spindle 33
maintain 26
new 55
not flat 222
physical marks 227
preset 54
remove preset 61
roll to collector 52
roll to free fall 50
roll to roll 36
shrinkage 228
sizes (max and min) 261
skewed 223
sticks to platen 226
supported types 22
telescoping 223
tips 26
unload 54
variable shrinkage 228
vibration noise 222
view information 54
wizard 55
wrinkles 224
substrate edge holders 30