●
The roll-to-free-fall configuration is suitable when you want to cut and remove one or more prints as
soon as they come out of the printer. The substrate is kept under tension between the input roll and the
tension roller; but it can be cut after the tension roller because then it is no longer under tension.
●
The roll-to-collector configuration is suitable when you may want to cut the substrate and remove the
output roll before finishing the print job being done using a particular input roll. The substrate is kept
under tension between the input roll and the tension roller; but it can be cut after the tension roller
because then it is no longer under tension.
Prepare to print
The following steps must be followed before the printer can print:
1. Go to the Internal Print Server and select Substrate Load/Unload to open the Printer Configuration
window.
ENWW Prepare to print 29
To Next Page
Loading...
