5. Close the latches at both sides.
6. Align the substrate by checking that the substrate edge is in the same position on the input spindle and
tension roller. This can be done by using the rulers on the spindle and tension roller or by measuring the
distance between the right edge and the side plate.
7. Ensure that the substrate is evenly tensioned and flat (no wrinkles or bumps), and close the tension
roller lever.
8. Go to the Internal Print Server and press the Finish button as in the roll-to-roll configuration.
Load a roll (roll-to-collector configuration)
This configuration is similar to the roll-to-free-fall configuration, but with the addition of a collector roller
and loop shaper.
TIP: Do not try to load or unload the collector while printing.
Before starting to load the substrate, select a loop shaper of the correct length to match the substrate width.
The following tubes are supplied so that you can make up loop shapers of many different lengths.
●
One 152-mm (6-in) tube
●
Two 203-mm (8-in) tubes
●
One 305-mm (12-in) tube
●
One 610-mm (24-in) tube
52 Chapter 3 Handle the substrate ENWW
To Next Page
Loading...
