Remove a substrate preset
To remove a substrate preset from your printer, go to the Internal Print Server and select Substrate >
Remove. Then select the category and type of the substrate you wish to remove from a list of removable
substrates.
Set the carriage beam position
The carriage beam position determines the vertical distance between the printheads and the platen. If it is
too great, print quality will be impaired. If it is too small, there is a risk that the printheads will come into
contact with the substrate, causing smears or damage.
●
The substrate-load position is not used for printing: it may be used for loading substrate or for
maintenance tasks.
●
A custom position is used for thick substrates, or for substrates that wrinkle slightly due to heating.
TIP: Try to avoid wrinkling by using substrates that do not wrinkle, or by using a slower print mode
that will allow you to lower the drying and curing power.
We recommend setting the custom position to the thickness of the substrate plus 2 to 3 mm for
substrates that wrinkle, or plus 1.5 to 2 mm for substrates that do not wrinkle.
●
The normal position is suitable for unwrinkled substrates up to 0.4 mm (0.016 in) thick.
WARNING! Keep away from the printer's moving parts until the carriage beam has reached its new position.
CAUTION: Do not change the carriage beam position while the printhead cleaning roll is out of place.
ENWW Remove a substrate preset 61
To Next Page
Loading...
