2. Disconnect the cartridge connector by pressing the tabs on each side of it and pulling it gently away
from the cartridge.
3. Remove the empty cartridge from the printer.
NOTE: Some residual ink can be expected in the cartridge, ranging from 2% to 5% of the original
content.
Insert an ink cartridge
NOTE: The ink cartridge is supplied in an insulating bag; do not open it until you are ready to use the
cartridge.
1. Check that the new cartridge is of the correct color.
2. Place the cartridge on a flat surface and turn it four times (rotating it through 360 degrees) as indicated
on the label, to ensure that the ink is well mixed before use.
3. Tear off the square and fold it inside the handle as illustrated.
4. Put the new cartridge into its correct place on the printer.
5. Check that the rubber part around the needle in the cartridge connector is clean. Clean gently if
necessary.
ENWW How to work with ink system components 73
To Next Page
Loading...
