13. Grip the handle and push the whole printhead cleaning roll assembly back into the printer. Ensure that
you push it as far as it will go.
14. Close and lock the door.
15. Click Finish in the wizard window.
The printhead cleaning roll length tracking is now reset to zero.
NOTE: If you tamper with half-used rolls, the usage shown in the Internal Print Server will not be accurate.
Do not empty or remove the drain container: this is done by a service engineer during preventive
maintenance.
Empty the condensation collector bottle
TIP: You are recommended to wear gloves for this operation.
The condensation collector bottle is stored behind the left cover at the front of the printer. You can see the
level of liquid in the bottle through a narrow window at the bottom of the cover.
92 Chapter 5 Handle the ink system ENWW
To Next Page
Loading...
