HP LJ 1100 - Page 24

22 Chapter 1 – Control-panel messages EN
NVRAM error (68)
Status log code: 30035 or
30036
l A memory error
resulted in one or
more printer settings
being reset to
factory defaults.
l Print a configuration
page and verify that
the printer setting
are set correctly.
l Turn the printer off.
Press and hold
J
OB CANCEL and
turn the printer on.
Keep J
OB CANCEL
depressed until all of
the control-panel
lights illuminate.
Release J
OB
C
ANCEL and send
the print job again.
l Replace the
formatter.
I/O error (81)
l The EIO accessory
has encountered a
critical error.
l Turn the printer off
and then on.
l If the error message
persists, turn the
printer off and reset
the EIO card. Turn
the printer on.
l Replace the EIO
card.
Continuable attention error secondary codes (continued)
Control-panel light
pattern
Continuable
attention error
secondary message
Recommended
action