38 Chapter 1 – Control-panel messages EN
An error was detected in the static random-access memory (SRAM).
1 Unplug the power cord from the power source, wait 10 seconds, and
then reconnect the power cord.
2 If the error persists, replace the formatter.
1 In Service mode, run the SRAM stuck address test.
2 Unplug the power cord from the power source, wait 10 seconds, and
reconnect the power cord.
3 If the error persists, replace the formatter.
1 In Service mode, run the SRAM tied address test.
2 Unplug the power cord from the power source, wait 10 seconds, and
reconnect the power cord.
3 If the error persists, replace the formatter.
The product does not have enough memory to complete the collated
copy job.
Continue completing the collated copy job.
The battery has failed.
You can continue to use the HP LaserJet product without replacing the
battery, but if you reenter the menu settings and then turn off the power,
the settings will be erased again.
Configuration err # (number 1-4)
Config. stuck addr
Config. tied addr
Copy count set to 1
[Date] [Time]
To Next Page
Loading...