40 Chapter 1 – Control-panel messages EN
1 Press START. A report is printed.
2 Check the fax log status column for the “Fax Document was Lost”
message.
3 Resend the associated outgoing faxes. Ask the sender to resend
incoming faxes.
1 Check the duplexer for a jam.
2 Make sure the right-angle power cord is used for the printer.
3 Reseat the duplex assembly, and check the connection.
4 Replace the duplex unit.
1 Reseat the EIO disk in the indicated slot [x].
2 If the problem persists, remove and replace the EIO disk.
1 Wait for the message to disappear (up to 5 minutes). If the printer
EIO card is operating correctly and communicating with the network,
this message disappears after approximately 1minute and no action
is required.
2 If the EIO card is unable to communicate with the network, this
message remains for 5 minutes and then disappears.
• Reseat or replace the indicated EIO card [x].
• Check the cable connections.
3 If the problem persists, contact the network administrator.
Documents were lost, START to continue
Duplex error, check duplexer
EIO [x] not functional
EIO [x] initializing alternates with
Do not power off
To Next Page
Loading...