78 Chapter 1 – Control-panel messages EN
The page containing the error will automatically be reprinted.
1 Check the power.
2 Replace the formatter and/or firmware DIMM.
3 Replace the ECU.
X = Description
1 = Illegal input or bad accessory connector
2 = Illegal output
The page containing the error automatically reprints.
1 Turn the printer off, and then turn the printer back on.
2 Check the printer configuration.
3 Verify the accessory connection.
X = Description
4 = Printer fan
7 = Duplex fan
1 Check the fan connector and make sure that the fan is not blocked.
2 Replace the fan.
55.xx Printer error alternates with
Cycle power to continue
56.x Printer error alternates with
Cycle power to continue
57.x Printer error alternates with
Cycle power to continue
To Next Page
Loading...