80 Chapter 1 – Control-panel messages EN
3200 series only
1 Disconnect the power cable from the product, wait at least 30
seconds, reconnect the power cable, and then wait for the product
to initialize.
2 If the error persists, replace the formatter.
4100 series only
X = Location of problem
0 = Internal memory
1 to 4 = DIMM slot 1, 2, 3, or 4
1 Reseat the specified DIMM.
2 Replace the specified DIMM.
1 Turn the printer off and then on.
2 Perform a cold reset.
3 If the message persists, replace the formatter or firmware DIMM.
62.x Printer error
62.x Printer error
64.x Printer error alternates with
Cycle power
To Next Page
Loading...