DescriptionError
While threading, the LM voltage was increased from 0.25V to 0.5V.7493h
While threading, the LM voltage was increased from 0.5V to 0.75V.7494h
While threading, the LM voltage was increased from 0.75V to 1.0V.7495h
Load command failed and no CM was detected, therefore it is likely there is no cartridge
present.
749Ah
General unload failure.74A0h
EP sensor did not transition while unloading.74A1h
CD sensor did not transition while unloading.74A2h
CG sensor did not transition while ungrabbing74A3h
LP sensor did not transition while ungrabbing74A4h
RD sensor stopped toggling while CG during ungrab.74A6h
RD sensor stopped toggling while LP during ungrab.74A7h
RD sensor stopped toggling while CD during ungrab.74A8h
RD sensor stopped toggling while CD during unload.74A9h
RD sensor stopped toggling while IT during unload.74AAh
Too much rotation of the cartridge was detected while the tape was not threaded.74ACh
The load, unload, grab or ungrab operation timed out.74ADh
Time-out while deslacking the cartridge.74C0h
Emergency stop error.74C1h
Already past target position.74C2h
Set speed time-out error.74C3h
Time-out waiting for an LPOS.74C4h
Reels not synchronized.74C5h
Safety limit stop reached.74C6h
LPOS calculation with invalid LP0.74C7h
Missed target position.74C8h
Previous tape motion command in progress.74C9h
Unthreading time-out error.74CBh
Remove slack process timed-out.74CCh
Leader may have disconnected.74CDh
Volume 1: hardware integration 121
To Next Page
Loading...
