6. Push the print-cartridge door button to release the scanner assembly, and then raise the assembly
until it locks open.
Figure 5-33 Remove the scanner assembly (5 of 10)
7. Disconnect two wire-harnesses and two FFCs (callout 3; J2, J33, J4, and J27) on the formatter,
and then remove the harnesses and FFC from the retainers.
Remove one screw (callout 4) to release the ground wire.
CAUTION: The ferrite and bracket are not captive when the ground screw is removed and can
be dislodged if the product is tilted or moved.
Do not bend or fold the FFCs during the removal or reinstallation process.
Figure 5-34 Remove the scanner assembly (6 of 10)
4
3
92 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...