10. Use a small flat-blade screwdriver to release the hinge tabs on each front hinge.
WARNING! When the front hinges are disengaged, the scanner assembly can easily fall off of
the product base if it is rotated too far toward the back of the product.
CAUTION: Do not push too hard on the link tabs or the tabs might break.
Figure 5-37 Remove the scanner assembly (9 of 10)
11. Rotate the scanner assembly toward the rear of the product until the rear hinges clear the chassis
hinge pins. Lift the scanner assembly off of the product base.
CAUTION: Make sure that the ADF cover and flatbed lid are supported so that they do not swing
open when you remove the scanner assembly.
NOTE: Do not lose the two scanner cushions in the scanner support-frame corners (one shown;
callout 5).
Figure 5-38 Remove the scanner assembly (10 of 10)
5
94 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...