Speaker assembly
1. Remove the left cover. See Side covers on page 104.
2. Disconnect one wire-harness connector (callout 1; J32) and remove the wire-harness from one
wire retainer (callout 2).
3. Remove one screw (callout 3) and the sheet-metal bracket (callout 4).
Figure 5-66 Remove the speaker assembly (1 of 2)
1
2
3
4
4. Release the speaker from the retaining clips and carefully slip the speaker out of the product
chassis.
CAUTION: The speaker will pass through the opening in the product chassis, but it is a tight fit
and you must carefully handle the speaker. Do not damage the paper cone of the speaker or pull
on the speaker wires.
Figure 5-67 Remove the speaker assembly (2 of 2)
ENWW Product base 111
To Next Page
Loading...