Formatter and fax card
CAUTION: The formatter and fax card are ESD-sensitive devices.
1. Remove the left cover. See Side covers on page 104.
2. Disconnect all FFCs and wire-harness from the formatter and fax card.
CAUTION: Do not bend or fold the FFCs during the removal or reinstallation process.
NOTE: The scanner assembly is shown removed in this procedure. If the scanner assembly is
installed, there will be additional FFCs and wire-harness connected to the formatter. You do not
need to remove the scanner assembly to remove the formatter and fax card.
3. Remove five screws from the formatter PCA (callout 1). Remove three screws (callout 2) from the
fax card. Remove the formatter and fax card.
Figure 5-68 Remove the formatter
1
2
ENWW Product base 113
To Next Page
Loading...