5. Lift the laser/scanner cover up and out of the product to remove it.
NOTE: When this cover is reinstalled, make sure that the slots (callout 4; one shown) in the lower
portion of the cover fit over the edge of the laser/scanner mounting shelf so that the cover is secure
and correctly fits inside the product.
Figure 5-84 Remove the laser/scanner (4 of 7)
4
6. Disconnect one FFC (callout 5).
CAUTION: Do not bend or fold the FFCs during the removal or reinstallation process.
Figure 5-85 Remove the laser/scanner assembly (5 of 7)
5
ENWW Product base 123
To Next Page
Loading...