Main motor
1. Remove the following assemblies:
●
Scanner assembly. See
Scanner assembly on page 90.
●
Formatter. See
Formatter and fax card on page 113.
●
Right and left cover. See
Side covers on page 104.
●
Print-cartridge door. See
Print-cartridge door on page 106.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 107.
●
Front cover. See
Front cover on page 109.
●
Scanner support-frame. See
Scanner support-frame on page 118.
●
Laser/scanner assembly. See
Laser/scanner assembly on page 121.
2. Remove one screw (callout 1) and then carefully disconnect one wire-harness connector (callout
2).
Figure 5-88 Remove the main motor (1 of 4)
1
2
ENWW Product base 125
To Next Page
Loading...