Clean the paper path
The product features a special cleaning mode to clean the paper path.
NOTE: If you have access to HP ToolboxFX, HP recommends cleaning the paper path by using
HP ToolboxFX.
1.
On the product control panel, press Setup
.
2. Use the arrow buttons to select Service, and then press OK.
3. Use the arrow buttons to select Cleaning Mode, and then press OK.
A page feeds through the product slowly. Discard the page when the process is completed.
4. Load plain letter or A4 paper when you are prompted.
5. Press OK again to confirm and begin the cleaning process.
A page feeds through the product slowly. Discard the page when the process is completed.
190 Chapter 6 Problem solve ENWW
To Next Page
Loading...