Top cover
1. Remove the following components:
●
Right-side cover (see
Right-side cover on page 94)
●
Formatter shield (see
Formatter shield on page 95)
●
Fax cover (see
Fax cover on page 96)
●
Left-side cover (see
Left-side cover on page 97)
●
Back cover (see
Back cover on page 101)
●
I/O cover (see
I/O cover on page 103)
●
ADF/scanner assembly (see
Scanner assembly on page 90)
●
Fax rail (see
Fax rail on page 104)
2. Remove two screws (callout 1) from each side of the device (a total of four screws).
1
Figure 5-26 Removing the top cover (1 of 3)
ENWW Covers 105
To Next Page
Loading...