Disk drive
1. Remove the right-side cover (see Right-side cover on page 94) and the formatter shield (see
Formatter shield on page 95).
2. Disconnect two cables (callout 1) and remove one screw (callout 2).
2
1
Figure 5-34 Removing the disk drive (1 of 3)
3. Slide the disk drive up slightly to clear three tabs from the tab slots (callout 3 in
Figure 5-35
Removing the disk drive (2 of 3) on page 114), and then lift the disk drive away from the device.
Reinstallation tip Upon reinstallation, make sure that all three tabs are inserted correctly
into the slots. Also make sure that the screw-hole tab on the disk drive housing is on top of
the tab in the device.
NOTE If you are replacing the disk drive, complete the additional steps below. If you are
removing the disk drive in order to replace the formatter or other parts, there is no need to
complete the remaining steps in this section.
ENWW Disk drive 113
To Next Page
Loading...