4. Place the paper in the tray and make sure that it is flat at all four corners. Keep the paper below
the height tabs on the paper-length guide in the rear of the tray.
5. Push down on the paper to lock the metal paper-lift plate in place.
6. Slide the tray into the device.
Configure trays
1. At the device control panel, touch Supplies Status.
2. Touch Trays.
3. Select the tray that you want to set and then touch Modify Tray.
4. Set the size and type of media that is loaded in the tray.
26 Chapter 2 Installation and configuration ENWW
To Next Page
Loading...