Clean the device
During the printing process, paper, toner, and dust particles can accumulate inside the product. Over
time, this buildup can cause print-quality problems, such as toner specks or smearing (see
Image defect
examples on page 476). This product has a cleaning mode that can correct and prevent these types of
problems.
Clean the exterior
Use a soft, damp, lint-free cloth to wipe dust, smudges, and stains off of the exterior of the device.
Clean the scanner glass
Dirty glass, from fingerprints, smudges, hair, and so on, can cause jams and poor print quality, and can
affect the accuracy of special features such as fit-to-page and copy.
NOTE If streaks or other defects appear only on copies produced using the automatic document
feeder (ADF), clean the ADF glass (step 3). It is not necessary to clean the scanner glass.
1. Open the scanner lid.
2. Clean the glass by using a damp, lint-free cloth.
CAUTION Do not use abrasives, acetone, benzene, ammonia, ethyl alcohol, or carbon
tetrachloride on any part of the device; these can damage the device. Do not place liquids
directly on the glass. They might seep under it and damage the device.
98 Chapter 3 Manage and maintain the device ENWW
To Next Page
Loading...