8. After specified interval from when the leading edge of the paper reaches the inlet paper sensor
(SR2100), the staple stacker driver turns the deflector solenoid (SL2100) OFF and returns the
delivery deflector to its original position.
Staple stacker
Printer
Deflector
Paper
Upper stacking roller
Lower stacking roller
SR2100
Jogger guide
Figure 4-50 Staple mode (4 of 7)
9. When the paper is released from the stacking rollers, the staple stacker driver rotates the motor
(M2100) for the jogger operation to align both sides of the paper.
10. The staple stacker driver reverses the motor (M2102) and turns the separation solenoid (SL2102)
ON to lower the leading-end alignment roller. The jogger guide aligns both the leading ends and
the sides of the paper.
Staple stacker
Leading end alignment roller
Paper
Upper stacking roller
Lower stacking roller
Alignment position
Jogger guide
Paper
Jogger guide
Figure 4-51 Staple mode (5 of 7)
11. The staple stacker driver repeats these steps until the last page is fed to the jogger guide.
164 Chapter 4 Theory of operation ENWW
To Next Page
Loading...