Required tools
●
#2 Phillips screwdriver with a magnetic tip and a 152-mm (6-inch) shaft length
NOTE For the best fit, use a JIS #2 Phillips screwdriver for the stapler/stacker.
●
Small, flat-blade screwdriver
●
Needle-nose pliers
●
ESD strap (if one is available)
●
Penlight
CAUTION Always use a Phillips screwdriver (callout 1). Do not use a pozidrive screwdriver
(callout 2) or any motorized screwdriver. These can damage screws or screw threads.
Figure 5-1 Screwdrivers
Types of screws
Illustration Description Size Use
Screw with washer M3X8 Used to secure metal
components to metal
components (for example, a
ground wire to the frame)
Screw, RS M3X6
M3X10
Used to secure metal to metal
Screw, tapping M3X6
Screw M3X8
ENWW Removal and replacement strategy 179
To Next Page
Loading...