4. Disconnect one connector (callout 2; J2100). Remove the FFC (callout 3) and the wire harnesses
from the retainers (callout 4).
2
3
4
Figure 5-122 Remove the stapler assembly (3 of 5)
5. Open the stapler front door and remove three screws (callout 4).
NOTE The stapler front door is shown removed in the figure below. Howerver, the door
does not need to be removed to remove the stapler assembly.
5
Figure 5-123 Remove the stapler assembly (4 of 5)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 255
To Next Page
Loading...