Paper feed assembly (base unit)
1. Remove the following components or assemblies:
●
Fuser. See
Fuser on page 329.
●
Transfer roller. See
Transfer roller on page 187
●
Registration assembly. See
Registration assembly on page 325.
2. Release two tabs (callout 1).
1
Figure 5-236 Remove the paper feed assembly (1 of 3)
3. Lift up on the shutter (callout 2) and then carefully lift up on the paper feed assembly and slide it
toward the rear of the device to release it. Remove the assembly.
2
Figure 5-237 Remove the paper feed assembly (2 of 3)
332 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...