3. Disconnect one connector (callout 6).
6
Figure 5-253 Remove the low-voltage power supply assembly (2 of 4)
4. Remove two black screws (callout 7) and two silver screws (callout 8). Carefully separate the low-
voltage power supply from the device.
CAUTION Do not fully remove the low-voltage power supply from the device. The power
supply wire-harness connectors are still connected.
Tip The chassis sheet metal is embossed with a star and arrow that mark the mounting
holes that require black screws.
8
7
Figure 5-254 Remove the low-voltage power supply assembly (3 of 4)
ENWW Print engine (base unit) 343
To Next Page
Loading...