Interconnect PCA assembly
1. Remove the following components or assemblies:
●
Formatter cover and cage. See
Formatter cover and cage on page 199.
●
Base unit rear cover. See
Rear cover on page 295.
●
Scanner back cover. See
Scanner controller board (SCB) and cover on page 230.
●
Stapler back cover. See
Rear cover on page 258.
2. Remove two black screws (callout 1) and four silver screws (callout 2). Remove the sheet-metal
shield (callout 3).
Tip The chassis sheet metal is embossed with a star and arrow that mark the mounting
holes that require black screws.
2
1
3
Figure 5-256 Remove the interconnect PCA (1 of 3)
ENWW Print engine (base unit) 345
To Next Page
Loading...