Control panel message Description Recommended action
To override the message, touch OK to use a
type and size of media that is available in
another tray.
Manually feed: <type>, <size> To
Continue Touch OK
Media is loaded in Tray 1 for a manual feed
job and the device is ready.
Touch OK to print the manual feed job.
Manually feed: <type>, <size> To Use
Another Tray Touch OK
Tray 1 is not loaded, but another tray is
configured and loaded with the requested
media size and type.
Touch OK to print the manual feed job.
Moving solenoid To Exit Press Stop The device is processing a component test. Press stop to exit the component test.
Network connection required for digital
sending. Contact administrator.
A digital-sending feature has been
configured, but a network connection is not
detected.
Verify the network connection. Contact the
network administrator.
No Job to Cancel The Stop button was pressed, but there was
no job to cancel.
No action necessary.
Non HP supply installed or Non HP supply
installed Economode disabled
A non-HP supply or a refilled HP supply has
been installed.
Follow the instructions in the onscreen dialog
box.
●
If you are certain that the print cartridge
is a genuine HP print cartridge, reseat
the cartridge and then check the
cartridge present sensor (SR9)
connector J309 on the dc controller
PCA.
●
Install a diferent print cartridge.
●
If the problem persists, replace the dc
controller. See
DC controller PCA
on page 357.
Novell Login Required Novell authentication has been enabled for
this destination.
Enter Novell network credentials to access
the copy and fax features.
Order black cartridge The number of pages remaining for the print
cartridge has reached the low threshold. The
device was set to stop printing when a supply
needs to be ordered.
Touch OK to continue printing until the print
cartridge is out of toner.
Make sure that the Supply Low/Order
Threshold setting is correct or has been
changed. From the control panel, select
Administration, Management, Manage
Supplies, and Supply Low/Order
Threshold.
Order a new print cartridge.
Order document feeder kit The number of pages remaining for the ADF
maintenance items has reached the low
threshold.
Follow the instructions on the control-panel
display, and then touch OK to return to the
Home screen.
Order and install a document feeder
maintenance kit.
Order maintenance kit The number of pages remaining for the
engine maintenance items has reached the
low threshold.
Follow the instructions on the control-panel
display, and then touch OK to return to the
Home screen.
Order and install an engine maintenance kit.
Table 6-2 Control-panel messages (continued)
ENWW Control-panel messages 437
To Next Page
Loading...