NOTE These examples depict letter-size media that has passed through the ADF.
See Poor uniformity
(flatbed) on page 496
See Poor uniformity
gradual (flatbed)
on page 496
See Lamp inverter
failure (flatbed)
on page 496
See Streaks on page
(flatbed) on page 497
See Unexpected
results (flatbed)
on page 497
NOTE These examples depict letter-size media that has copied by using the flatbed glass.
Light print (partial page)
1. Make sure that the print cartridge is fully installed. The print-cartridge door should close completely
when the cartridge is fully seated.
2. The toner level in the print cartridge might be low. Remove the cartridge and shake it to redistribute
the toner. Replace the print cartridge.
3. The media might not meet HP specifications (for example, the media is too moist or too rough).
4. The transfer roller might be worn or damaged. Replace the transfer roller if necessary. See
Transfer
roller on page 187.
478 Chapter 6 Troubleshooting ENWW
To Next Page
Loading...