I/O configuration
●
USB configuration
●
Network configuration
USB configuration
This device supports a USB 2.0 connection.
Figure 2-4 USB connection
1 USB connector device (use for printing)
2 USB port host
Network configuration
You might need to configure certain network parameters on the device. You can configure these
parameters in the following locations:
●
Installation software
●
Device control panel
●
Embedded Web server
●
Management software (HP Web Jetadmin or HP LaserJet Utility for Macintosh)
NOTE For more information about using the embedded Web server, see Use the embedded
Web server on page 30
For more information on supported networks and network configuration tools, see the HP Jetdirect Print
Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect print server is
installed.
This section contains the following information about configuring network parameters:
●
Configure TCP/IPv4 parameters
●
Configure TCP/IPv6 parameters
●
Disable network protocols (optional)
ENWW I/O configuration 21
To Next Page
Loading...