Page skew
1. Print a few more pages to see if the problem corrects itself.
2. Verify that no torn pieces of media are inside the device.
3. Make sure that media is loaded correctly and that all adjustments have been made. Make sure that
the guides in the tray are not too tight or too loose against the media.
4. Turn over the stack in the tray. Also, try rotating the stack 180°.
5. Make sure that the type and quality of the media you are using meet HP specifications.
6. Make sure that the environmental specifications for the device are being met. (See
Operating
environment on page 826.)
7. Perform a tray alignment by opening the Administration menu at the device control panel. On
the Print Quality submenu, touch Set Registration. Choose a tray under Source and then run a test
page. For more information, see
Print Quality menu on page 64.
8. The registration assembly is not installed correctly or is damaged.
Make sure that the registration assembly is installed correctly. If necessary, replace the registration
assembly.
ENWW Solving image-quality problems 489
To Next Page
Loading...