Menu item Sub-menu item Sub-menu item Values Description
Paper Path Sensors Use this item to display the status of the paper
path sensors during a Paper Path Test.
1. Select Paper Path Test from the
Troubleshooting menu.
2. Press the Hide button.
3. Select Paper Path Test from the
Troubleshooting menu.
Use the menus to define the source,
destination, duplex, and number of
copies options, and then select Print
Test Page.
4. The paper path test page will print. At
the same time, the status of the paper
path sensors will appear on the control-
panel display (0 = inactive; 1 = active).
Use the following list to Identify the
sensors that appear on the control-
panel display.
●
A: TOP sensor (SR5)
●
B: LOOP sensor (SR4)
●
C: fuser output sensor (SR6)
●
D: FD output sensor (SR7)
●
E: output tray bin full sensor (SR1)
●
F: lower path sensor (SR14)
●
G: duplex unit switchback sensor
(duplexer SR2)
●
H: duplex unit re-feed sensor
(duplexer SR1)
5. Press Stop to exit the test.
Table 3-17 Troubleshooting menu (continued)
68 Chapter 3 Manage and maintain the device ENWW
To Next Page
Loading...