Removal and replacement procedures 33
5. Remove the DIMM baffle.
To replace the component, reverse the removal procedure.
Fan blank
To remove the component:
1. Power down the server (on page 26).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Front bezel" on page 28).
o Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the large redundant fan air baffle, if installed ("Large redundant fan air baffle" on page
31).
To Next Page
Loading...
