Removal and replacement procedures 53
4. Close the heatsink locking levers.
5. Install the large redundant fan air baffle, if removed.
6. Install the access panel.
7. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
Processor
The server supports single- and dual-processor operation. With two processors installed, the server
supports boot functions through the processor installed in processor socket 1. However, if processor 1
fails, the system boots automatically from processor 2 and provides a processor failure message.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To help avoid damage to the processor and system board, do not install the
processor without using the processor installation tool.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
To remove the component:
1. Power down the server (on page 26).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Front bezel" on page 28).
o Extend the server from the rack (on page 25).
3. Place the tower server on its side.
4. Remove the access panel ("Access panel" on page 29).
To Next Page
Loading...
